Vulcan C24EA6 Manuel d'utilisateur télécharger pdf (Page 10)

MODEL C24EA - DOOR

F35453 (July 2008) Page 10 of 68

Installation

1. Install latch assembly onto inner door panel with

spring pin toward bottom of door panel.

A. Apply Loctite 271 to threads of screws

before assembly and secure latch

assembly to inner door panel.

2. Install outer door housing assembly as outlined

under DOOR HANDLE.

3. Check opening and closing operation of door.

4. Check steamer for proper operation and leaks

around door seal.

HINGE BEARINGS

1. Close door.

2. Remove COOKING COMPARTMENT LEFT

SIDE PANEL as outlined under COVERS AND

PANELS.

3. Remove nuts from upper hinge located inside

front panel.

4. Open door slightly, and while holding door, pull

upper hinge away from front panel.

5. Pull upper hinge out of upper door hinge

bearing.

6. Lift door assembly up and off lower door hinge.

7. Pry hinge bearing out from door assembly.

8. Remove outer door housing.

Do not drive bearing into place. The inner

door panel could be damaged. Press bearing into

position.

NOTE: When replacing door hinge bearings, replace

both hinge bearings.

9. Position replacement hinge bearing over hinge

opening in door assembly.

A. Press hinge bearing fully into door

assembly using a C-clamp or equivalent.

10. Reassemble parts removed in reverse order.

11. Check door for fit and proper door gasket

sealing.

DOOR LATCH ADJUSTMENT

Opening a Jammed Door

Should the steamer door jam and cannot

be opened, do not force or pry the door as damage

will occur.

1. Lift up on bottom of door at the handle end to

disengage latch.

A. If door does not open, remove COOKING

COMPARTMENT RIGHT SIDE PANEL as

outlined under COVERS AND PANELS.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Vulcan C24EA6 Manuel d'utilisateur Page 10

Commentaires sur ces manuels