Vulcan 705 Manuel d'utilisateur télécharger pdf (Page 10)

8 •

705 & 705S OWNER/OPERATOR MANUAL

MODELS

Model 705: Tenderizer (includes tenderizer blade and frame assembly).

Model 705S: Stir-Fry Cutter (includes stir-fry cutter blade and frame assembly).

Model SFC: Stir-Fry Blade and Frame Assembly (to convert 705 and earlier model Berkel to

optional stir-fry cutter use).

TROUBLESHOOTING

Should your tenderizer fail to function properly, here are a few things you can check before calling a

Designated Berkel Service Location for service.

Product not tenderizing or slicing properly:

1. Are the knives/blades dull or bent? If so, contact your nearest Designated Berkel Service Loca-

tion for replacement.

2. Does the product size exceed the capacity of the tenderizer? Too large a product may rub against

the cover or frame assembly causing interference to normal slicing or tenderizing.

3. Are the blade assemblies securely mated to the driving gears? If not, make sure that the basket

assembly is pushed all the way to the left.

Electrical failure:

1. Is tenderizer fully plugged into a properly grounded 120 volt AC outlet?

2. Inspect power cord. Has it been damaged, cutting off electrical flow? If so, call your Designated

Berkel Service Location to replace the power cord.

3. Is ON/OFF switch in the ON position?

4. Are you getting electricity from the wall outlet? Check by plugging in another piece of equip-

ment with the same electrical requirements. Also, check circuit breaker or fuse

5. Is the Lexan cover completely down?

6. If you are getting electrical power and your tenderizer is still not operating, contact your Desig-

nated Berkel Service Location.

If correction of any of the above conditions does not result in a functional tenderizer, call your

Designated Berkel Service Location.

1 2 ... 5 6 7 8 9 10 11 12

Pas de commentaire

Vulcan 705 Manuel d'utilisateur Page 10