Vulcan VSX3E Manuel d'utilisateur télécharger pdf (Page 6)

VSX SERIES STEAMER - REMOVAL AND REPLACEMENT OF PARTS

Page 6 of 40

(Gas Model Shown)

REMOVAL AND REPLACEMENT OF PARTS

COVERS AND PANELS

WARNING:

DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AT THE MAIN

CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT

BOX INDICATING THE CIRCUIT IS BEING

SERVICED.

Right Side Panel

1. Remove screws from the bottom of the panel.

2. Slide panel down to clear the top cover.

3. Reverse procedure to install.

Top Cover

1. Remove screws from the top rear of cover. If

steamer is a gas model, follow steps 1A and 1B.

A. Remove the screws at the base of the

exterior flue housing and lift off.

B. Remove the screws that secure the flue to

the tank and lift it off.

2. Push up on the rear of the cover and slide the

top cover forward to clear the front edge.

3. Lift the cover off the cabinet.

4. Reverse procedure to install.

Left Side and Rear Panel

1. Remove the top cover screws an disconnect the

utilities.

1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Pas de commentaire

Vulcan VSX3E Manuel d'utilisateur Page 6