Vulcan VSX3E Manuel d'utilisateur télécharger pdf (Page 7)

VSX SERIES STEAMER - REMOVAL AND REPLACEMENT OF PARTS

Page 7 of 40

2. Remove the screws at the bottom of panel.

3. Remove the lower access panels on the right

and left side of the unit to gain access to the

lower compartment.

4. Remove the screws Inside the lower

compartment that run along the top rear of the

base frame that secure the lip of the rear panel.

NOTE:

Rear panel lip is “sandwiched” between the

base frame and the top lip of the small rear access

panel.

5. Pull the combination left side and rear panel off.

6. Reverse procedure to install.

THERMOSTATS

WARNING:

DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AT THE MAIN

CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT

BOX INDICATING THE CIRCUIT IS BEING

SERVICED.

1. Turn “off” the water supply and allow hot parts to

cool down if necessary.

2. Remove the right side panel as outlined under

"COVERS AND PANELS".

3. Manually drain the steam generator tank if

necessary, as outlined in "DRAIN TANK

MANUALLY”.

4. Disconnect the lead wires from thermostat being

replaced.

5. Remove screws that secure the thermostat.

6. If replacing the control thermostat, fully loosen

the compression nut, sliding it away from tank,

then remove the bulb.

NOTE:

When installing, do not over tighten as

thermostat calibration and/or damage to thermostat

may occur.

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Pas de commentaire

Vulcan VSX3E Manuel d'utilisateur Page 7